Citrix Systems Network Router NETSCALER 9.3 Instrukcja Użytkownika Pobierz pdf (Strona 133)

Down Service Reset status : DISABLED

Nagle's Algorithm : DISABLED

Limited Persist Probes : ENABLED

Maximum out-of-order packets to queue: 64

Done

To enable SACK by using the Configuration Utility

1. In the navigation pane, expand System, and click Settings.

2. In the details pane, under Settings, click Change TCP Parameters.

3. In the Configure TCP Parameters dialog box, under TCP, select the Selective

Acknowledgment check box, and then click OK.

A message appears in the status bar, stating that SACK has been configured

successfully.

Clearing the Configuration

You have the following three options for clearing your NetScaler configuration.

Basic level. Clearing your configuration at the basic level clears all settings except the

following:

w NSIP, MIP(s), and SNIP(s)

w Network settings (Default Gateway, VLAN, RHI, NTP, and DNS settings)

w HA node definitions

w Feature and mode settings

w Default administrator password (nsroot)

Extended level. Clearing your configuration at the extended level clears all settings

except the following:

w NSIP, MIP(s), and SNIP(s)

w Network settings (Default Gateway, VLAN, RHI, NTP, and DNS settings)

w HA node definitions

Feature and mode settings revert to their default values.

Full level. Clearing your configuration at the full level returns all settings to their

factory default values. However, the NSIP and default gateway are not changed,

because changing them could cause the NetScaler to lose network connectivity.

To clear a configuration by using the NetScaler

command line

At the NetScaler command prompt, type the following command:

Citrix NetScaler Administration Guide

133

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 194 195

Brak uwag

Citrix Systems Network Router NETSCALER 9.3 Instrukcja Użytkownika Strona 133